FUJITSU XG Series P3NK-4452-01ENZD - Manual (Page 151)

XG Series User's Guide Chapter 5 Command Reference
Port Information Settings 151
5.1.10 ether output rate control information
This section explains about the commands related to ether output rate control information.
5.1.10.1 ether ratecontrol
Function Set output rate limit of ether port
Available Model XG2600
Syntax ether ratecontrol
Options
• ether port number
Set a port number to use with a decimal value.
When setting multiple port numbers, separate them with commas (,).
When setting sequential numbers, separate them with hyphens (-). (Example: "1-8")
• Output rate
Specify output rate which is limited in the ether port with Mbps or Gbps
40m to 10000m
1g to 10g
If "10000m" or "10g" is set, packets are not limited.
Use Mode Configuration mode (admin class)
Explanation Set output rate control.
Caution "ether qos mode drr" command and "ether ratecontrol" command can not use at the
same time and same port.
Default It is assumed that the output rate limit function is not used.