FUJITSU XG Series P3NK-4452-01ENZD User Manual
Page 202
XG Series User's Guide
Chapter 5 Command Reference
LAN Information Settings
202
Note 3.
This command is unavailable if the allowable upper limit for the device is exceeded.
The allowable upper limits are as follows.
• Upper limit based on "commands"
128 commands for the entire device.
Up to 128 commands can be set for the entire device, including the
and
commands.
The priority for each command is as follows.
1)
command
A smaller VLAN ID has a higher priority among VLANs.
2)
A smaller lan definition number has a higher priority among lans.
If up to 128 of
commands have been defined, the subsequent
command will be no longer applied.
• Upper limit based on rule
128 rules for the entire device.
For the
and
commands, the number of rules to be used
varies depending on the contents of the specified acl as shown below.
The number of rules for each ACL is as follows.
- For ACL to set TCP or UDP
Result of multiplication between the number of source ports and the number of
destination ports for TCP or UDP
- For ACL to set ICMP
Result of multiplication between the number of ICMP TYPEs and the number of
ICMP CODEs for ICMP
- For ACL not to set TCP, UDP, or ICMP
1
You can expand the upper limit to use
"resource filter distribution"
resource distribution.
Note 4.
Up to 700 commands can be set for the entire device, including the definitions which refer
to ACL such as
,
and "serverinfo filter" commands.
Default
It is assumed that the IPv6 filter is not set.