FUJITSU XG Series P3NK-4452-01ENZD User Manual
Page 195
XG Series User's Guide
Chapter 5 Command Reference
LAN Information Settings
195
4)
command
A smaller lan definition number has a higher priority among lans.
The following commands spend 1 action regardless of multiple use.
- vlan
- vlan
The following commands spend 1 action for each.
If same
If same
If same
- ether
- ether
- ether
- vlan
- vlan
- vlan
- lan
The following commands spend 1 action for each.
If same
- vlan
- vlan
[XG0224/XG0448]
Note 2.
This command is unavailable if the allowable upper limit for the device is exceeded.
The allowable upper limits are as follows.
• Upper limit based on "commands"
128 commands for the entire device.
Up to 128 commands can be set for the entire device, including the
commands.
1)
A smaller Ethernet port value has a higher priority among Ethernet ports.
2)
A smaller VLAN ID has a higher priority among VLANs.
3)
command
A smaller lan definition number has a higher priority among lans.
If up to 128 of
commands have been defined for port ether1, the
subsequent "vlan qos aclmap" and "lan ip dscp"command will be no longer applied.
• Upper limit based on rule
128 rules for the entire device.
For the
and
number of rules to be used varies depending on the contents of the specified acl as
shown below.
The number of rules for each ACL is as follows.
- For ACL to set TCP or UDP
Result of multiplication between the number of source ports and the number of
destination ports for TCP or UDP