FUJITSU XG Series P3NK-4452-01ENZD - Manual (Page 152)

XG Series User's Guide Chapter 5 Command Reference
LACP Information Settings 152
5.2 LACP Information Settings
This section explains about LACP information settings.
5.2.1 LACP Information
This section explains about the commands related to LACP information.
5.2.1.1 lacp system-priority
Function Set the LACP system priority.
Available Model XG0224 / XG0448 / XG2600
Syntax lacp system-priority
Options
• Priority of LACP system
Set the device priority with a decimal value from 1 to 65535.
A smaller value has a higher priority.
Use Mode Configuration mode (admin class)
Explanation Set the priority of LACP system. The LACP system priority is used to determine which
has a higher priority for the information exchange between a link aggregation group and
another remote link aggregation group. If the priority is same, the system ID (the
designated MAC address +1) with a smaller number has the higher priority.
However, this definition is meaningless if the active or passive is not set for the
linkaggregation operation mode of the "linkaggregation mode".
Default It is assumed that 32768 has been specified as the LACP system priority.
lacp system-priority 32768