FUJITSU XG Series P3NK-4452-01ENZD - Manual (Page 39)

XG Series User's Guide Chapter 2 Using the CLI
Overview of the CLI 39
for the device as below.
A VT100, VT200, or xterm can be used as a terminal.
2.1.2 Command Modes and Mode Switching
The following table shows a hierarchy of command modes and mode switching.
2.1.2.1 Command Operation Procedure
The flow of system operation via command execution is as follows:
1) Login to the device.
2) Run an operation command to manage system operations.
3) Run a configure command to move to configuration mode.
4) Run a configuration command to set candidate configuration (candidate-config).
5) Run a commit command to apply the candidate configuration as a running configuration (running-config).
6) Run a save command to save the candidate configuration as a startup configuration (startup-config).
7) Run an exit or similar command to return to operation mode.
8) Repeat steps 2) through 7)
9) Run an exit command to log out.
XG2600(config)# ether 1 vlan untag 1
XG2600(config)# lan 0 vlan 1
XG2600(config)# lan 0 ip 192.168.1.1/24 3
XG2600(config)# commit
XG2600(config)# save
Reference " Login to the device" (pg.40) , "2.1.2.2 Executable commands" (pg.42)
Login
user name
Operation mode
Operation command
Configuration mode
Candidate configuration
(candidate-config) Running configuration
(running-config)
Startup configuration
(startup-config)
Operation command
Configuration command
User
class
Admin
class exit / ! exit
user
admin
admin / su
Admin
class exit / ! / end / quit
load
reset / Reconnect power
commit
exit
save
load
configure