FUJITSU XG Series P3NK-4452-01ENZD - Manual (Page 575)

XG Series User's Guide Chapter 6 Managing the Device
Actions When Firmware Update Failes (Backup Firm Function) 575
3. Connect the power cable to the power outlet.
4. Insert the power cable into the power connector while pressing the reset switch on the back of this
device using a pointed tool. After about five seconds, release the reset switch.
The power is turned on and the backup firmware is started.
Precautions
If you do not release the reset switch within 10 seconds after turning on the device, it is regarded as reset switch failure.
Be sure release the reset switch within 10 seconds.
• XG2600
• XG0224/XG0448
Note
• It takes about one minute to start the backup firmware.
• The Ready LED blinks in green when the backup firmware is running.
• If you start the backup firmware to logon with the console connected, the "backup#" message is displayed on the console
screen.
[XG0224] [XG0448]