FUJITSU XG Series P3NK-4452-01ENZD - Manual (Page 280)

XG Series User's Guide Chapter 5 Command Reference
Device Information Settings 280
5.15.2 System Log Information
This section explains about the commands related to system log information.
5.15.2.1 syslog server address
Function Set the server IP address that receives system log information.
Available Model XG0224 / XG0448 / XG2600
Syntax syslog server address
Options
• Definition number
Specify the definition number of the server that receives system log information
(message) with a decimal value from 0 to 2.
Specify the IP address of the server that receives system log information (message).
The allowable range is as follows:
1.0.0.1 to 126.255.255.254
128.0.0.1 to 191.255.255.254
192.0.0.1 to 223.255.255.254
Use Mode Configuration mode (admin class)
Explanation Set the server IP address that receives system log information (message).
The following describes the procedure for outputting system log information.
1) Send information to a server the host with the IP address set in syslog server
2) Display information with the "show logging syslog" command.
Caution If STP is used, it takes a long time for transmission to be enabled after device startup.
During this time, some messages are discarded before reaching the server.
When transferring system logs to a Linux server, be sure to enable remote logging by
using the "-syslogd -r" command or editing the syslog init file to include the "-r" qualifier.
Default It is assumed that the server that receives system log information is not specified.