FUJITSU XG Series P3NK-4452-01ENZD - Manual (Page 265)

XG Series User's Guide Chapter 5 Command Reference
Device Information Settings 265
5.15.1.7 snmp manager
Function Set the SNMP host information.
Available Model XG0224 / XG0448 / XG2600
Syntax snmp manager
Options
• SNMP host definition number
Specify a serial number of SNMP host definition with a decimal value from 0 to 7.
Specify an IP address to permit access and to send a trap to, in the
XXX.XXX.XXX.XXX format, where "XXX" indicates a 3-digit decimal value.
Specifying 0.0.0.0 will permit access by all hosts without trap sending.
The allowable range is as follows:
1.0.0.1 to 126.255.255.254
128.0.0.1 to 191.255.255.254
192.0.0.1 to 223.255.255.254
Specify the community name.
• Community name
Specify the community name for trap sending with up to 32 characters.
• public
Specify it when communicating with any of the SNMP managers.
Specify whether or not to perform trap transmission.
• off
Specify it when not performing trap transmission.
• v1
Specify it when performing SNMPv1 trap transmission.
• v2c
Specify it when performing SNMPv2 trap transmission.
Specify whether or not to permit writing from the SNMP manager.
• enable
Specify it when enabling writing from the SNMP manager.
• disable
Specify it when disabling writing from the SNMP manager.
The default is "disable".
Use Mode Configuration mode (admin class)
Explanation Set the SNMP host information.
Default It is assumed that no SNMP host information is set.