FUJITSU XG Series P3NK-4452-01ENZD - Manual (Page 146)

XG Series User's Guide Chapter 5 Command Reference
Port Information Settings 146
5.1.7 LACP Information
This section explains about the commands related to LACP information.
5.1.7.1 ether lacp port-priority
Function Set the LACP port priority.
Available Model XG0224 / XG0448 / XG2600
Syntax ether lacp port-priority
Options
• ether port number
Set a port number to use with a decimal value.
When setting multiple port numbers, separate them with commas (,).
When setting sequential numbers, separate them with hyphens (-). (Example: "1-8")
• Priority of LACP port
Set the port priority with a decimal value from 1 to 65535.
A smaller value has a higher priority.
Use Mode Configuration mode (admin class)
Explanation Set the priority of LACP port. The LACP port priority is used as the priority for the
connection port to be selected by the link aggregation group. A smaller value has a
higher priority. If the priority is the same, the port with a smaller number has the higher
priority in port selection.
It indicates the priority of port selection in the local device. The final port selection for the
final connection depends on the LACP system priority.
However, this definition is no use if the active or passive is not specified for the
linkaggregation operation mode of "the linkaggregation mode".
Default It is assumed that 32768 has been specified as the LACP port priority.
ether lacp port-priority 32768