H3C Technologies H3C SecPath F1000-E - Manual (Page 78)

66
AFT configuration task list
Complete the following tasks to configure AFT for communication initiated by an IPv6 host:
Task Remarks
Enabling AFT Required.
Configuring a DNS64 prefix Required.
Configuring an IVI prefix Required.
Perform either one.
Configuring a 6to4 AFT policy
Complete the following tasks to configure AFT for communication initiated by an IPv4 host:
Task Remarks
Enabling AFT Required.
Configuring a DNS64 prefix Required.
Configuring an IVI prefix Required.
Configuring 4to6 AFT policies Required.
Configuring AFT
Configuration prerequisites
Before configuring AFT:
• Enable IPv6 on the AFT. For more information, see Network Management Configuration Guide.
• Configure an IPv4 or IPv6 address as required on the interface on which AFT is to be enabled.
Enabling AFT
You must enable AFT on both the interface connected to the IPv4 network and the interface connected to
the IPv6 network.
To enable AFT:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view. interface interface-type interface-number N/A
3. Enable AFT on the interface. aft enable Disabled by default