Configuring l2tp in the web interface, L2tp configuration task list, Enabling l2tp – H3C Technologies H3C SecPath F1000-E User Manual
Page 253
241
Configuring L2TP in the Web interface
NOTE:
•
Only the LNS configuration is available in the web interface.
•
When an L2TP user group is created, the firewall automatically creates a VT interface with the same
number as the user group. If a VT interface with the same number already exists, it is overwritten by the
newly created VT interface.
L2TP configuration task list
Task Remarks
Required.
By default, L2TP is disabled.
Required.
Create a L2TP group and configure L2TP group related
parameters.
By default, no L2TP group is created.
Displaying L2TP tunnel information
Optional.
View the L2TP tunnel information.
Enabling L2TP
Select VPN > L2TP > L2TP Config from the navigation tree to enter the L2TP configuration page, as shown
in
. On the upper part of the page, you can enable or disable L2TP.
Figure 154 L2TP configuration page
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS