H3C Technologies H3C SecPath F1000-E User Manual
Page 227
215
a.
Log in to the Web interface of SecPath A, select High Reliability > Stateful Failover from the
navigation tree to enter the Stateful Failover Configuration page.
b.
Click the Modify Backup Interface button.
c.
Select and add GigabitEthernet 0/3 to the Backup Interface(s) list as shown in
.
Figure 132 Configuring a backup interface
d.
Click Apply to return to the Stateful Failover Configuration page and perform the
configurations shown in
.
Figure 133 Configuring stateful failover
2.
Configure VRRP:
# Create VRRP group 1 and assign a virtual IP address to the group.
[SecPathA] interface GigabitEthernet 0/1
[SecPathA-GigabitEthernet0/1] vrrp vrid 1 virtual-ip 10.1.1.1
# Set the priority of SecPath A in VRRP group 1 to 150.
[SecPathA-GigabitEthernet0/1] vrrp vrid 1 priority 150
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS