H3C Technologies H3C SecPath F1000-E - Manual (Page 240)

228
Figure 140 IPsec VPN policy configuration wizard: 2/4 (branch node)
3. Configure the parameters as described in Table 18 .
Table 18 Configuration items
Item Description
IPSec VPN Name
Enter the name for the IPsec VPN.
IMPORTANT:
If you enter abc here, the wizard will create an IKE peer named abc_peer, an
IPsec proposal named abc_prop, and an IPsec policy named abc_poli and
numbered 1. The IKE peer and IPsec proposal will be referenced in the IPsec
policy.
IPSec Interface Select the interface to which you want to apply the IPsec policy.
Center IP Address
Enter the IP address of the center node, which will be used during IKE
negotiation.
IMPORTANT:
The IP address specified here must match the local IP address specified on the
peer.
Center Gateway Name
Enter the name of the remote gateway at the center node, which will be used
during IKE negotiation.
Identity
Configuration
Local IP
Address
Specify the ID type of the local end for IKE negotiation phase 1. Options
include:
• Local IP Address—Uses the IP address of the local gateway as the ID. If you
do not specify the IP address, the default (the primary IP address of the
interface using the security policy) is used.
• Local Gateway Name—Uses the name of the local gateway as the ID. If you
do not specify the gateway name, the default (the device name) is used.
Local
Gateway
Name