H3C Technologies H3C SecPath F1000-E - Manual (Page 222)

210
Using the display ripng command on SecPath A, you will see the running status and configuration
information of the specified RIPng process. The output shows that IPsec policy policy001 is applied to this
process successfully.
display ripng 1
RIPng process : 1
Preference : 100
Checkzero : Enabled
Default Cost : 0
Maximum number of balanced paths : 8
Update time : 30 sec(s) Timeout time : 180 sec(s)
Suppress time : 120 sec(s) Garbage-Collect time : 120 sec(s)
Number of periodic updates sent : 186
Number of trigger updates sent : 1
IPsec policy name: policy001, SPI: 123456
Using the display ipsec sa command on SecPath A, you will see the information about the inbound and
outbound SAs.
display ipsec sa
===============================
Protocol: RIPng
===============================
-----------------------------
IPsec policy name: "policy001"
sequence number: 10
mode: manual
-----------------------------
connection id: 1
encapsulation mode: transport
perfect forward secrecy:
tunnel:
flow:
[inbound ESP SAs]
spi: 123456 (0x3039)
proposal: ESP-ENCRYPT-DES ESP-AUTH-SHA1
No duration limit for this sa
[outbound ESP SAs]
spi: 123456 (0x3039)
proposal: ESP-ENCRYPT-DES ESP-AUTH-SHA1
No duration limit for this sa
Similarly, you can view the information on SecPath B and SecPath C. (Details not shown.)