Figure 38 – H3C Technologies H3C SecPath F1000-E User Manual
Page 52
40
Figure 38 Adding a GRE over IPv4 tunnel interface (Tunnel1)
4.
Configure a static route from SecPath C through interface Tunnel 0 to the headquarters node, with
the routing priority being 1:
a.
Select Network > Routing Management > Static Routing from the navigation tree.
b.
Click Add to perform the configurations shown in
c.
Enter 192.168.11.0 as the destination IP address.
d.
Select mask 255.255.255.0.
e.
Select Tunnel0 as the outbound interface.
f.
Enter priority 1.
g.
Click Apply.
Figure 39 Adding a static route from SecPath C through interface Tunnel0 to the headquarters node
5.
Configure a static route from SecPath C through interface Tunnel1 to the headquarters node, with
the routing priority being 10.
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS