H3C Technologies H3C SecPath F1000-E - Manual (Page 276)

264
[LAC-luser-vpdnuser] quit
# Configure interface Async 1/0.
[LAC] interface async 1/0
[LAC-Async1/0] ip address 1.1.1.1 255.255.255.0
[LAC-Async1/0] ppp authentication-mode chap
[LAC-Async1/0] quit
# Enable L2TP.
[LAC] l2tp enable
# Create an L2TP group and configure its attributes.
[LAC] l2tp-group 1
[LAC-l2tp1] tunnel name LAC
[LAC-l2tp1] start l2tp ip 1.1.2.2 fullusername vpdnuser
# Enable tunnel authentication and specify the tunnel authentication password.
[LAC-l2tp1] tunnel authentication
[LAC-l2tp1] tunnel password simple aabbcc
2. Configure the LNS:
# Configure IP addresses for the interfaces. (Details not shown.)
# Create a local user named vpdnuser, set the password, and enable the PPP service. The
username and password must match those configured on the client.
system-view
[LNS] local-user vpdnuser
[LNS-luser-vpdnuser] password simple Hello
[LNS-luser-vpdnuser] service-type ppp
[LNS-luser-vpdnuser] quit
# Configure local authentication for the VPN user.
[LNS] domain system
[LNS-isp-system] authentication ppp local
[LNS-isp-system] ip pool 1 192.168.0.2 192.168.0.100
[LNS-isp-system] quit
# Enable L2TP.
[LNS] l2tp enable
# Configure the virtual template interface.
[LNS] interface virtual-template 1
[LNS-virtual-template1] ip address 192.168.0.1 255.255.255.0
[LNS-virtual-template1] ppp authentication-mode chap domain system
[LNS-virtual-template1] remote address pool 1
[LNS-virtual-template1] quit
# Add the virtual template interface to a proper security zone. For how to add an interface to a
security zone, see Access Control Configuration Guide.
# Create an L2TP group, specify the virtual template interface for receiving calls and specify the
name of the tunnel on the peer.
[LNS] l2tp-group 1
[LNS-l2tp1] tunnel name LNS
[LNS-l2tp1] allow l2tp virtual-template 1 remote LAC
# Enable tunnel authentication and specify the tunnel authentication password.
[LNS-l2tp1] tunnel authentication