Verifying the configuration – H3C Technologies H3C SecPath F1000-E User Manual
Page 59
47
Figure 48 Adding a GRE over IPv4 tunnel interface
3.
Configure a static route from SecPath C through interface Tunnel0 to the headquarters node:
a.
Select Network > Routing Management > Static Routing from the navigation tree.
b.
Click Add to perform the configurations shown in
c.
Enter 172.17.17.0 as the destination IP address.
d.
Select mask 255.255.255.0.
e.
Select Tunnel0 as the outbound interface.
f.
Click Apply.
Figure 49 Adding a static route from SecPath C through interface Tunnel0 to the headquarters node
Verifying the configuration
1.
On Host B, specify SecPath C as the default gateway. Ping Host A from Host B. The ping operation
succeeds.
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS