H3C Technologies H3C SecPath F1000-E - Manual (Page 145)

133
Configuration procedure
1. Configure the IKE peer on Device A:
a. Select VPN > IKE > Peer from the navigation tree and then click Add.
The IKE peer configuration page appears, as shown in
Figure 91 .
b. Perform the following operations on the page:
Enter peer as the peer name.
Select Main as the negotiation mode.
Enter 2.2.2.2 as the remote gateway IP address.
Select Pre-Shared Key and enter abcde as the pre-shared key.
c. Click Apply.
Figure 91 Configuring the IKE peer
2. Create an IKE proposal numbered 10 on Device A:
a. Select VPN > IKE > Proposal from the navigation tree and then click Add.
The IKE proposal configuration page appears, as shown in
Figure 92 .
b. Perform the following operations on the page:
Enter 10 as the IKE proposal number.
Select Preshared Key as the authentication method.
Select MD5 as the authentication algorithm.