H3C Technologies H3C SecPath F1000-E - Manual (Page 109)

97
[RouterA] interface tunnel 0
[RouterA-Tunnel0] ipv6 address 2002:0201:0101::1/64
[RouterA-Tunnel0] source GigabitEthernet 0/2
[RouterA-Tunnel0] tunnel-protocol ipv6-ipv4 6to4
[RouterA-Tunnel0] quit
# Configure a static route to the 6to4 relay router.
[RouterA] ipv6 route-static 2002:0601:0101:: 64 tunnel 0
# Configure the default route to the IPv6-only network.
[RouterA] ipv6 route-static :: 0 2002:0601:0101::1
• Configure Router B:
# Enable IPv6.
system-view
[RouterB] ipv6
# Configure an IPv4 address for GigabitEthernet 0/2.
[RouterB] interface GigabitEthernet 0/2
[RouterB-GigabitEthernet0/2] ip address 6.1.1.1 255.255.255.0
[RouterB-GigabitEthernet0/2] quit
# Configure an IPv6 address for GigabitEthernet 0/1.
[RouterB] interface GigabitEthernet 0/1
[RouterB-GigabitEthernet0/1] ipv6 address 2001::1/16
[RouterB-GigabitEthernet0/1] quit
# Configure a 6to4 tunnel.
[RouterB] interface tunnel 0
[RouterB-Tunnel0] ipv6 address 2002:0601:0101::1/64
[RouterB-Tunnel0] source GigabitEthernet 0/2
[RouterB-Tunnel0] tunnel-protocol ipv6-ipv4 6to4
[RouterB-Tunnel0] quit
# Configure a static route whose destination address is 2002::/16 and next-hop is the tunnel
interface.
[RouterB] ipv6 route-static 2002:: 16 tunnel 0
Verifying the configuration
After the above configuration, ping Host B from Host A.
D:\>ping6 -s 2002:201:101:1::2 2001::2
Pinging 2001::2
from 2002:201:101:1::2 with 32 bytes of data:
Reply from 2001::2: bytes=32 time=13ms
Reply from 2001::2: bytes=32 time=1ms
Reply from 2001::2: bytes=32 time=1ms
Reply from 2001::2: bytes=32 time<1ms
Ping statistics for 2001::2:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 13ms, Average = 3ms