H3C Technologies H3C SecPath F1000-E - Manual (Page 130)

118
[RouterB] ipv6
# Configure an IPv6 address for GigabitEthernet 0/1.
[RouterB] interface GigabitEthernet 0/1
[RouterB-GigabitEthernet0/1] ipv6 address 2002:3::1 64
[RouterB-GigabitEthernet0/1] quit
# Configure an IPv6 address for GigabitEthernet 0/2 (the physical interface of the tunnel).
[RouterB] interface GigabitEthernet 0/2
[RouterB-GigabitEthernet0/2] ipv6 address 2002::22:1 64
[RouterB-GigabitEthernet0/2] quit
# Create interface Tunnel 2.
[RouterB] interface tunnel 2
# Configure an IPv6 address for interface Tunnel 2.
[RouterB-Tunnel2] ipv6 address 3001::1:2 64
# Configure the tunnel encapsulation mode.
[RouterB-Tunnel2] tunnel-protocol ipv6-ipv6
# Configure a source address for interface Tunnel 2 (IP address of GigabitEthernet 0/2).
[RouterB-Tunnel2] source 2002::22:1
# Configure a destination address for interface Tunnel 2 (IP address of GigabitEthernet 0/2 of
Router A).
[RouterB-Tunnel2] destination 2002::11:1
[RouterB-Tunnel2] quit
# Configure a static route from Router B through interface Tunnel 2 to Group 1.
[RouterB] ipv6 route-static 2002:1:: 64 tunnel 2
Verifying the configuration
Display the status of the tunnel interfaces on Router A and Router B.
[RouterA] display ipv6 interface tunnel 1
Tunnel1 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::2013:1
Global unicast address(es):
3001::1:1, subnet is 3001::/64
Joined group address(es):
FF02::1:FF13:1
FF02::1:FF01:1
FF02::1:FF00:0
FF02::2
FF02::1
MTU is 1460 bytes
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
IPv6 Packet statistics:
...
[RouterB] display ipv6 interface tunnel 2
Tunnel2 current state :UP
Line protocol current state :UP