H3C Technologies H3C SecPath F1000-E - Manual (Page 211)

199
Figure 127 Network diagram
Configuring SecPath A
# Define an ACL to identify data flows from subnet 10.1.1.0/24 to subnet 10.1.2.0/24.
system-view
[SecPathA] acl number 3101
[SecPathA-acl-adv-3101] rule permit ip source 10.1.1.0 0.0.0.255 destination 10.1.2.0
0.0.0.255
[SecPathA-acl-adv-3101] quit
# Configure a static route to Host B.
[SecPathA] ip route-static 10.1.2.0 255.255.255.0 GigabitEthernet 0/2
# Create an IPsec proposal named tran1.
[SecPathA] ipsec proposal tran1
# Specify the encapsulation mode as tunnel.
[SecPathA-ipsec-proposal-tran1] encapsulation-mode tunnel
# Specify the security protocol as ESP.
[SecPathA-ipsec-proposal-tran1] transform esp
# Specify the algorithms for the proposal.
[SecPathA-ipsec-proposal-tran1] esp encryption-algorithm des
[SecPathA-ipsec-proposal-tran1] esp authentication-algorithm sha1
[SecPathA-ipsec-proposal-tran1] quit
# Create manual IPsec policy map1.
[SecPathA] ipsec policy map1 10 manual
# Apply the ACL.
[SecPathA-ipsec-policy-manual-map1-10] security acl 3101
# Apply the IPsec proposal.
[SecPathA-ipsec-policy-manual-map1-10] proposal tran1
# Configure the remote IP address of the tunnel.
[SecPathA-ipsec-policy-manual-map1-10] tunnel remote 2.2.3.1
# Configure the local IP address of the tunnel.
[SecPathA-ipsec-policy-manual-map1-10] tunnel local 2.2.2.1
# Configure the SPIs.
[SecPathA-ipsec-policy-manual-map1-10] sa spi outbound esp 12345
[SecPathA-ipsec-policy-manual-map1-10] sa spi inbound esp 54321