Verifying the configuration, Figure 27 – H3C Technologies H3C SecPath F1000-E User Manual
Page 44
32
Figure 27 Adding a GRE over IPv4 tunnel interface
3.
Configure a static route from Device B through interface Tunnel0 to the headquarters node:
a.
Select Network > Routing Management > Static Routing from the navigation tree.
b.
Click Add to perform the configurations shown in
c.
Enter 192.168.11.0 as the destination IP address.
d.
Select mask 255.255.255.0.
e.
Select Tunnel0 as the outbound interface.
f.
Click Apply.
Figure 28 Adding a static route from Device B through interface Tunnel0 to the headquarters node
Verifying the configuration
1.
On Device A, select VPN > GRE > P2MP from the navigation tree, and then click the Tunnel List tab
to view the tunnel entries. There should be no tunnel entry.
2.
Ping Host A from Host B. The ping operation succeeds.
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS