H3C Technologies H3C SecPath F1000-E - Manual (Page 284)

272
[LNS-isp-aaa.net] quit
[LNS] domain bbb.net
[LNS-isp-bbb.net] authentication ppp local
[LNS-isp-bbb.net] ip pool 1 10.0.2.10 10.0.2.100
[LNS-isp-bbb.net] quit
# Create two virtual template interfaces.
[LNS] interface virtual-template 1
[LNS-Virtual-Template1] ip address 10.0.1.1 255.255.255.0
[LNS-Virtual-Template1] remote address pool 1
[LNS-Virtual-Template1] ppp authentication-mode chap domain aaa.net
[LNS-Virtual-Template1] quit
[LNS] interface virtual-template 2
[LNS-Virtual-Template2] ip address 10.0.2.1 255.255.255.0
[LNS-Virtual-Template2] remote address pool 1
[LNS-Virtual-Template2] ppp authentication-mode chap domain bbb.net
[LNS-Virtual-Template2] quit
# Add each virtual template interface to a proper security zone. For how to add an interface to a
security zone, see Access Control Configuration Guide.
# Create two L2TP groups.
[LNS] l2tp-group 3
[LNS-l2tp3] tunnel name LNS
[LNS-l2tp3] tunnel authentication
[LNS-l2tp3] allow l2tp virtual-template 1 remote LAC-1 domain aaa.net
[LNS-l2tp3] tunnel password simple 12345
[LNS-l2tp3] quit
[LNS] l2tp-group 4
[LNS-l2tp4] tunnel name LNS
[LNS-l2tp4] tunnel authentication
[LNS-l2tp4] allow l2tp virtual-template 2 remote LAC-1 domain bbb.net
[LNS-l2tp4] tunnel password simple 12345
If RADIUS authentication is required on the LNS, modify the AAA configurations as needed. For more
information about AAA configuration, see Access Control Configuration Guide.
3. Configure the users:
Create a dial-up connection on each host.
{
On Host A, enter [email protected] as the username and 11111 as the password in the dial-up
terminal window.
{
On Host B, enter [email protected] as the username and 22222 as the password in the dial-up
terminal window.
4. Verify the configuration:
# After Host A establishes a dial-up connection with enterprise 1, Host A obtains the IP address
10.0.1.10 and can ping the private address of the LNS (10.0.1.1).
# After Host B establishes a dial-up connection with enterprise 2, Host B obtains the IP address
10.0.2.10 and can ping the private address of the LNS (10.0.2.1).
# On the LNS, use the display l2tp session command to check the established L2TP sessions.
[LNS-l2tp1] display l2tp session