H3C Technologies H3C SecPath F1000-E - Manual (Page 451)

439
e. Click More>> to perform OSPF interface configuration.
f. Click the icon of interface Tunnel1.
g. Enter 10 as the Hello interval, enter 40 as the Dead interval, select P2MP as the network type,
select 0 as the DR priority, and click Apply.
Verifying the configuration
1. From the navigation tree of the main VAM server, select VPN > DVPN > Server. Click the VAM
Client Info tab to view the address mapping information of all VAM clients that have registered
with the main VAM server.
Figure 323 Viewing WAM client information on the main VAM server
The previous figure shows that Hub 1, Hub 2, Spoke 1, and Spoke 2 all have registered their address
mapping information with the main VAM server.
2. From the navigation tree of the backup VAM server, select VPN > DVPN > Server. Click the VAM
Client Info tab to view the address mapping information of all VAM clients that have registered
with the backup VAM server.
Figure 324 Viewing WAM client information on the backup VAM server
The previous figure shows that Hub 1, Hub 2, Spoke 1, and Spoke 2 all have registered their address
mapping information with the backup VAM server.
3. From the navigation tree of Hub 1, select VPN > DVPN > Client. Click the DVPN Session tab to view
all DVPN session information.