Applying an ipsec policy group, Applying an ipsec policy, Group – H3C Technologies H3C SecPath F1000-E User Manual
Page 183

171
Item Description
Next Hop
Specify a next hop for the static routes.
If you do not specify any next hop, the remote tunnel endpoint’s address learned
during IPsec SA negotiation is used.
Priority
Change the preference of the static routes.
Change the route preference for equal-cost multipath (ECMP) routing or route
backup. If multiple routes to the same destination have the same preference, traffic
is balanced among them. If multiple routes to the same destination have different
preference values, the route with the highest preference forwards traffic and all
other routes are backup routes.
Applying an IPsec policy group
1.
Select VPN > IPSec > IPSec Application from the navigation tree to enter the IPsec policy
application configuration page.
Figure 116 IPsec policy application
2.
Click the
icon for an interface.
3.
Select an IPsec policy for the interface.
4.
Click Apply.
Figure 117 IPsec policy application page
Table 14 Configuration items
Item Description
Interface
Displays the interface you selected.
Policy
Select an IPsec policy group for the interface.
无法显示链接的图像。该文件
可能已被移动、重命名或删
除。请验证该链接是否指向正
确的文件和位置。
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS