H3C Technologies H3C SecPath F1000-E - Manual (Page 102)

90
Figure 72 Network diagram
Configuration procedure
NOTE:
Before configuring an IPv6 manual tunnel, make sure that Router A and Router B are reachable to each
other.
• Configure Router A:
# Enable IPv6.
system-view
[RouterA] ipv6
# Configure an IPv4 address for GigabitEthernet 0/2.
[RouterA] interface GigabitEthernet 0/2
[RouterA-GigabitEthernet0/2] ip address 192.168.100.1 255.255.255.0
[RouterA-GigabitEthernet0/2] quit
# Configure an IPv6 address for GigabitEthernet 0/1.
[RouterA] interface GigabitEthernet 0/1
[RouterA-GigabitEthernet0/1] ipv6 address 3002::1 64
[RouterA-GigabitEthernet0/1] quit
# Configure an IPv6 manual tunnel.
[RouterA] interface tunnel 0
[RouterA-Tunnel0] ipv6 address 3001::1/64
[RouterA-Tunnel0] source GigabitEthernet 0/2
[RouterA-Tunnel0] destination 192.168.50.1
[RouterA-Tunnel0] tunnel-protocol ipv6-ipv4
[RouterA-Tunnel0] quit
# Configure a static route to IPv6 Group 2 through Tunnel 0 on Router A.
[RouterA] ipv6 route-static 3003:: 64 tunnel 0
• Configure Router B:
# Enable IPv6.
system-view
[RouterB] ipv6
# Configure an IPv4 address for GigabitEthernet 0/2.
[RouterB] interface GigabitEthernet 0/2
[RouterB-GigabitEthernet0/2] ip address 192.168.50.1 255.255.255.0
[RouterB-GigabitEthernet0/2] quit
# Configure an IPv6 address for GigabitEthernet 0/1.