Configuring secpath c, Figure 47 – H3C Technologies H3C SecPath F1000-E User Manual
Page 58
46
Figure 47 Adding a static route from SecPath B through interface Tunnel0 to the headquarters node
Configuring SecPath C
1.
Configure an IPv4 address for each interface and assign the interfaces to security zones. (Details
not shown.)
2.
Create a GRE over IPv4 tunnel interface:
a.
Select VPN > GRE > GRE from the navigation tree.
b.
Click Add to perform the configurations shown in
c.
Enter 0 in the Tunnel Interface field.
d.
Enter IP address/mask 192.168.22.3/24.
e.
Select Management from the Zone list. (Select a security zone according to your network
configuration.)
f.
Enter the tunnel source IP address 11.1.1.3.
g.
Enter the tunnel destination IP address 11.1.1.1.
h.
Enter the GRE key 2.
i.
Click Apply.
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS