Rockwell Automation 193-EC1_2_3_5, 193-ECPM,592-EC1_2_3_5 E3 and E3 Plus Solid-State Overload Relay User Manual - Manual (Page 100)

100 Rockwell Automation Publication 193-UM002I-EN-P - December 2011
Chapter 4 DeviceNet™ Node Commissioning
5. Type the node address that you want in the New Device Settings section.
In this example, the new node address is 5.
6. Select Apply.
7. Select Exit to close the Node Commissioning window.
8. Select Single Pass Browse from the Network drop-down menu to update
the RSNetWorx software and verify that the node address is set correctly.
Produced and Consumed Assembly Configuration
The Input and Output Assembly format for the E3 Overload Relay is identified
by the value in Output Assembly, Parameter 59, and Input Assembly, Parameter
60. These values determine the amount and arrangement of the information
communicated to the master scanner.
NOTE: When the new node address has been successfully applied, the
Current Device Settings section of the window is updated (see the
example below). If an error occurs, check to see if the device is
properly powered up and connected to the network.