HP StorageWorks Scalable File Share - Manual (Page 62)

Viewing system information 4–6
Integrated Management Log (IML) events
Critical Caution
-------- -------
0 0
4.1.1 Server information after system parameter is changed
If certain system parameters (such as the
Start IP address
of an interconnect) are changed (using the
configure server command, as described in Section 7.1), the servers are using an actual configuration that
differs from the parameters in the database. To indicate this, the system changes the state of the server to
not-configured
, as shown in the following example:
sfs> show server
Name State Power Services
---------- -------------- -------- ----------
south1 not-configured on (was admin)
south1 not-configured on (was mds22)
south2 not-configured on (was ost65)
south3 not-configured on (was ost66)
In addition, the status for an individual server (as shown by the
show server server_name
command)
is also changed to indicate that the configure server command must be run to update interconnect
configuration on the server. The server’s status is shown as
Run configure server command to
update to latest configuration
, as shown in the following example:
sfs> show server south4
Name: south4
Primary Role: ost
Backup Server: south3
Server Firmware Model: 29
Server Firmware Date: 09/15/2004
iLO Firmware: 1.82
Current Config. State: Clusterized
Desired Config. State: Configured
Status: Run configure server command to update to latest
configuration
State: not-configured
.
.
.
To recover from this situation, follow the procedures described in Table 7-1 in Chapter 7.
CAUTION: If you do not follow the correct procedures for changing system parameters, client nodes may
be unable to access or mount file systems.
4.2 Viewing file system information
The
show filesystem
command shows information about file systems.
To determine whether file systems have been started or stopped, and to see configuration information about
file systems, enter the
show filesystem
command, as shown in the following example:
sfs> show filesystem
Name State Services
------------- -------------- ----------------------------------
data started mds3: running, ost[10-15]: running
The file system states (shown in the
State
field) are described in Table 4-2.