beautypg.com

Mds server -3, Mds server (section 8.1.1) – HP StorageWorks Scalable File Share User Manual

Page 201

background image

Replacing hardware components

8–3

Replacing a Voltaire InfiniBand switch (Section 8.1.27)

Relocating an InfiniBand cable to a different port on the InfiniBand switch (Section 8.1.28)

Replacing a Power Distribution Unit (PDU) on a rack (Section 8.1.29)

Replacing a Power Distribution Module (AC power strip) on a rack (Section 8.1.30)

Replacing a Power Distribution Unit (PDU) on an HP ProCurve Switch 2650 or HP ProCurve Switch

2626 (Section 8.1.31)

8.1.1 Replacing the administration or MDS server, or the motherboard

component in the administration or MDS server

CAUTION:

The process described here assumes that when a server is replaced, the PCI adapters and the

internal disks are moved from the old server to the new server.
If the internal disks are not moved from the old server to the new server, you must perform the procedure

described in Section 8.1.4.

Configuration impact

Changes the MAC address of the server on the management network.

Changes the license host ID on the server. As a result of this, a license check on the server will fail,

and the

create filesystem

and

start filesystem

commands will not work on the server

until you get new licenses from HP.

Process

1.

Configure the BIOS system and the iLO component in the new server, as described in Chapter 6 and

Chapter 7 of the HP StorageWorks Scalable File Share System Installation and Upgrade Guide.

2.

Run the

scan mac

command for the server, for example:

sfs> scan mac south2
sfs>

3.

Reboot the server.

4.

Enter the

show license

command on the server and note the host ID of the server displayed in the

output.

5.

Go to the

http://licensing.hp.com

Web site to retrieve the licensing contact information.

6.

Send a copy of your existing license file (

/var/flexlm/license.lic

) and the new host ID of the

server to HP by email or fax. (You will find the email and fax details on the licensing Web site.)

While you are waiting for the new license file, you can use the

create filesystem

and

start

filesystem

commands on the peer server (for example, if you replaced the administration server

or the mother board in the administration server, you can run the commands on the MDS server).

7.

When you receive your new licenses from HP, use the instructions provided in Section 3.11.3 to install

the new licenses.