HP StorageWorks Scalable File Share User Manual
Page 186
Changing the system parameters
7–4
Configure the
network device on
all servers
Yes
1.
Unmount the file systems on all client nodes.
2.
Log in to the administration server and stop the file systems by
entering the
stop filesystem filesystem_name
command
for each file system.
3.
Enter the
show filesystem
command and verify that all MDS
and OST services used by the file systems are stopped.
4.
Run the
configure system
command to change the parameter
value (see Section 7.2).
5.
Run the
configure server
command for all servers (see
6.
Start the file systems.
7.
When the file systems restart, the client nodes can remount the file
systems. If a client node fails to remount a file system, reboot the
client node.
Networks/Bonded Gigabit Ethernet Network Parameters
Add a Bonded
Network device
Yes
See Section 8.3.5.
Delete a Bonded
Network device
Yes
Type of network
No
N/A
Slave devices
Yes
1.
Unmount the file systems on all client nodes.
2.
Log in to the administration server and stop the file systems by
entering the
stop filesystem filesystem_name
command
for each file system.
3.
Enter the
show filesystem
command and verify that all MDS
and OST services used by the file systems are stopped.
4.
Run the
configure system
command to change the parameter
value (see Section 7.2).
(Note that you can add or remove slave devices.)
5.
Run the
configure server
command for all servers (see
6.
Start the file systems.
7.
When the file systems restart, the client nodes can remount the file
systems. If a client node fails to remount a file system, reboot the
client node.
Table 7-1
Procedures for changing parameters
Parameter
Can be
Changed?
Procedure for Changing