HP StorageWorks Scalable File Share - Manual (Page 190)

Changing the system parameters 7–8
The remainder of this section is organized as follows:
• Using the configure system command (Section 7.2)
• Using the configure server command (Section 7.3)
• Adding, changing, or removing the Alias IP on a Gigabit Ethernet network (Section 7.4)
• Partitioning an InfiniBand interconnect (Section 7.7)
• Removing InfiniBand partitioning (Section 7.8)
• Changing the iLO user name and password (Section 7.9)
7.2 Using the configure system command
As described in Table 7-1, the first step in changing a parameter value is usually to run the
configure
system
command. This section describes how to use this command to change a parameter value; as an
example, the
Alias IP
on a Gigabit Ethernet network is changed in the following steps:
1. Display the existing parameter value by entering the
configure system
command, and then
choosing the appropriate menu. In this example, the
Configure Networks
menu is chosen:
sfs> configure system
1) System
2) Configure Networks
3) Network Services
4) Management Network
5) iLO Access
6) Storage
a) All of the above
e) Exit (save updates)
q) Quit (discard updates)
Enter your choice [a]: 2
iLO Parameters
ILO User Name
Yes See Section 7.9.
ILO Password
Yes See Section 7.9.
Storage Parameters
Admin/MDS servers
with shared storage
No N/A
OSS servers with
shared storage
No N/A
root
User Password
root
user password Yes Enter the following command on the administration server:
sfs> set password root
Please enter new root password:
Please retype root password:
The password entries are not echoed to the screen.
Run the
configure server
command for all servers (see
Section 7.3).
Do not use the
passwd
(1) command to change the root user
password.
Table 7-1 Procedures for changing parameters
Parameter Can be
Changed?
Procedure for Changing