HP StorageWorks Scalable File Share - Manual (Page 188)

Changing the system parameters 7–6
Networks/InfiniBand Interconnect Parameters
Configure an
InfiniBand
Interconnect
Yes 1. Unmount the file systems on all client nodes.
2. Log in to the administration server and stop the file systems by
entering the
stop filesystem filesystem_name
command
for each file system.
3. Enter the
show filesystem
command and verify that all MDS
and OST services used by the file systems are stopped.
4. Run the
configure system
command to change the parameter
value (see Section 7.2).
5. Run the
configure server
command for all servers (see
Section 7.3).
6. Start the file systems.
7. When the file systems restart, the client nodes can remount the file
systems. If a client node fails to remount a file system, reboot the
client node.
Add IB Interface
Yes See Section 7.7.
Delete IB Interface
Yes See Section 7.8.
Type of network
No N/A
InfiniBand
Interconnect Start
IP
Yes This procedure describes how to change the
Start IP
address on
an InfiniBand interconnect.
Note that you can also change the IP address on individual servers.
For information on how to make this change, see Section 7.5.
1. Unmount the file systems on all client nodes.
2. Log in to the administration server and stop the file systems by
entering the
stop filesystem filesystem_name
command
for each file system.
3. Enter the
show filesystem
command and verify that all MDS
and OST services used by the file systems are stopped.
4. Run the
configure system
command to change the parameter
value (see Section 7.2).
5. Run the
configure server
command for all servers (see
Section 7.3).
6. Start the file systems.
7. When the file systems restart, the client nodes can remount the file
systems. If a client node fails to remount a file system, reboot the
client node.
InfiniBand
Interconnect
Netmask
Yes 1. Run the
configure system
command to change the parameter
value (see Section 7.2).
2. Run the
configure server
command for all servers (see
Section 7.3).
InfiniBand
Interconnect MTU
Yes 1. Run the
configure system
command to change the parameter
value (see Section 7.2).
2. Run the
configure server
command for all servers (see
Section 7.3).
InfiniBand
Interconnect
Partition Key
Yes 1. Run the
configure system
command to change the parameter
value (see Section 7.2).
2. Run the
configure server
command for all servers (see
Section 7.3).
InfiniBand
Interconnect Device
No N/A
Table 7-1 Procedures for changing parameters
Parameter Can be
Changed?
Procedure for Changing