HP StorageWorks Scalable File Share User Manual
Page 189
Changing system parameters
7–7
Networks/Quadrics Interconnect Parameters
Quadrics
Interconnect
Machine ID
Yes
1.
Run the
configure system
command to change the parameter
value (see Section 7.2).
2.
Run the
configure server
command for all servers (see
Network Services Parameters
Gateway IP
Yes
1.
Run the c
onfigure system
command to change the parameter
value (see Section 7.2).
If you want to remove (delete) a previously configured gateway IP
address without replacing it with a new one, type in
None
when
prompted to enter the IP address for the gateway router.
2.
Run the
configure server
command for all servers (see
DNS Server (1)
DNS Server (2)
DNS Server (3)
Yes
1.
Run the
configure system
command to change the parameter
value (see Section 7.2).
If you want to remove (delete) a previously configured DNS
server IP address without replacing it with a new one, type in
None
when prompted to enter the IP address for the DNS server.
2.
Run the
configure server
command for the administration
server and for the MDS server (see Section 7.3).
NTP Server (1)
NTP Server (2)
NTP Server (3)
Yes
1.
Run the
configure system
command to change the parameter
value (see Section 7.2).
If you want to remove (delete) a previously configured NTP server IP
address without replacing it with a new one, type in
None
when
prompted to enter the IP address for the NTP server.
2.
Run the
configure server
command for the administration
server and for the MDS server (see Section 7.3).
Mail Server IP
Yes
1.
Run the
configure system
command to change the parameter
value (see Section 7.2).
If you want to remove (delete) a previously configured mail server IP
address without replacing it with a new one, type in
None
when
prompted to enter the IP address for the mail server.
2.
Run the
configure server
command for the administration
server and for the MDS server (see Section 7.3).
Default Alert
e-mail address
1.
Run the
configure system
command to change the parameter
value (see Section 7.2)..
2.
Run the
configure server
command for the administration
server and for the MDS server (see Section 7.3).
Management Network Parameters
Management Network
Start IP
No
N/A
Management Network
Netmask
No
N/A
Network device
(NIC) attached to
management network
No
N/A
IP alias on
management network
No
N/A
ILO Start IP
No
N/A
Table 7-1
Procedures for changing parameters
Parameter
Can be
Changed?
Procedure for Changing