Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 996)

974 Fabric OS Message Reference
53-1003140-01
ZONE-1054
5
ZONE-1054
Message
Default Zone All Access mode is set with Frame Redirection zones.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the Default Zone All Access mode will not grant all access behavior when the frame
redirection zones are defined.
Recommended
Action
Remove frame redirection zones or set the Default Zone access mode to No Access using the defzone
--noaccess command.
ZONE-1057
Message
TI Zone has domain
running pre FOS6.4.0 firmware. TI member (Domain ,
Index ) is not supported.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that an unsupported port index (> 511) is present in the TI zone path or the routing may not be
set up correctly.
Recommended
Action
Remove the port index from the TI zone using the zone --remove name command.
ZONE-1058
Message
Domain present in TI zone
zone name> became unreachable due to failover disabled mode.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the domain present in the TI zone path is unreachable. This occurs if the TI zone paths are
unavailable or the TI zone is set up incorrectly.
Recommended
Action
Verify that the paths defined by TI zones are online or remove the domain from the TI zone using the
zone --delete name command.