Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 335)

Fabric OS Message Reference 313
53-1003140-01
EM-1061
5
EM-1061
Message
Synchronization halted. Remove all blades of type or upgrade your
standby CP, then reboot or run haSyncStart.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the blade in the system is not supported by the firmware on the standby control processor
(CP).
Recommended
Action
Remove all blades of the specified type or upgrade the standby CP. After an appropriate action is taken,
restart the standby CP or execute the haSyncStart command to enable the high availability (HA) state
synchronization. Until this is done, the system will remain out of synchronization.
EM-1062
Message
Blade in slot faulted as it exceeds the maximum support limit of
blades with Blade ID in the chassis.
Message Type
LOG
Severity
CRITICAL
Probable Cause
Indicates that too many blades of a particular type are in the system.
Recommended
Action
Remove the faulted blade.
EM-1063
Message
Blade in slot faulted because it exceeds the maximum support limit of
blades with Blade IDs in the chassis.
Message Type
LOG
Severity
CRITICAL
Probable Cause
Indicates that too many blades of a set of particular types are in the system.
Recommended
Action
Remove the faulted blade.