Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 938)

916 Fabric OS Message Reference
53-1003140-01
SWCH-1025
5
SWCH-1025
Message
This Logical Switch has ports other than 16 Gbps-capable FC ports. Edge Hold Time
for these ports is unchanged and is .
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the edge hold time for the non 16 Gbps-capable FC ports is not the same as 16
Gbps-capable FC ports in the logical switch. The non 16 Gbps-capable FC ports use the edge hold time
configured on the default switch.
Recommended
Action
To know the edge hold time configured for non 16 Gbps-capable FC ports, go to the default switch and
execute the configShow command.
SWCH-1026
Message
HA state out of sync: Standby CP (ver = ) does not support
auto csctl_mode (Active CP version = ).
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the standby control processor (CP) does not support auto class-specific control (CS_CTL)
mode.
Recommended
Action
Upgrade the standby CP firmware version to same level as active CP.
SWCH-1027
Message
HA state out of sync: Standby CP (ver = ) does not support
NPIV Base device Logout functionality. (active ver = ).
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the standby control processor (CP) does not support N_Port ID Virtualization (NPIV) base
device logout functionality, but the switch has some ports with base device configured.
Recommended
Action
Load a firmware version on standby CP that supports NPIV Base device Logout functionality using the
firmwareDownload command, or change the 'base logout' feature with the portCfgNPIVPort
command.