Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 478)

456 Fabric OS Message Reference
53-1003140-01
FICU-1004
5
FICU-1004
Message
: Failed to set FICON Management Server (FMS) mode: conflicting PID
Format:, FMS Mode:.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that a process ID (PID) format conflict was encountered. The core PID format is required for
fibre connectivity control unit port (FICON-CUP).
The pid_format variable displays the PID format currently running on the fabric, and is one of the
following:
• 0 - VC-encoded PID format
• 1 - Core PID format
• 2 - Extended-edge PID format
The mode variable displays whether FICON Management Server (FMS) mode is enabled, and is one of
the following: 0 means FMS mode is enabled and 1 means FMS mode is disabled.
Recommended
Action
To enable FMS mode, the core PID format must be used in the fabric. Change the PID format to core PID
using the configure command and re-enable FMS Mode using the ficonCupSet command. Refer to the
Fabric OS Administrator's Guide for information on core PID mode.
FICU-1005
Message
Failed to initialize , rc = .
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that initialization of a module within the fibre connectivity control unit port (FICON-CUP)
daemon failed.
Recommended
Action
Download a new firmware version using the firmwareDownload command.
FICU-1006
Message
Control Device Allegiance Reset: (Logical Path: 0x:0x).
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the path with the specified process ID (PID) and channel image ID lost allegiance to a fibre
connectivity control unit port (FICON-CUP) device.