Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 937)

Fabric OS Message Reference 915
53-1003140-01
SWCH-1022
5
SWCH-1022
Message
Port: has been disabled due to port address conflict while enabling
FMS mode.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the switch has ports with FICON Management Server (FMS) reserved areas (0xFE, 0xFF)
that are not supported in FMS mode.
Recommended
Action
No action required. Refer to the FICON Administrator's Guide for more information.
SWCH-1023
Message
HA state out of sync: Standby CP (ver = ) does not support
XISL use while fmsmode and/or lossless are enabled (Active CP version =
version>).
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the standby control processor (CP) does not support extended inter-switch link (XISL)
while FICON Management Server (FMS) mode and Lossless are enabled.
Recommended
Action
Load a firmware version on standby CP that supports both XISL use and FMS mode and Lossless at the
same time by using the firmwareDownload command.
SWCH-1024
Message
HA state out of sync: Standby CP (ver = ) does not support
active's enforce_login policy (Active CP version =).
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the standby control processor (CP) does not enforce login policy of the active CP.
Recommended
Action
Configure the enforce login policy to a value that the standby CP supports.