Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 773)

Fabric OS Message Reference 751
53-1003140-01
SEC-1003
5
SEC-1003
Message
Fail to download security data to domain after
retries.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates the specified domain failed to download security data after the specified number of attempts,
and that the failed switch encountered an error accepting the database download. The primary switch will
segment the failed switch after 30 tries.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
SEC-1005
Message
Primary FCS receives data request from domain .
Message Type
LOG
Severity
INFO
Probable Cause
Indicates the primary fabric configuration server (FCS) received a data request from the specified
domain. For example, if the switch fails to update the database or is attacked (data injection), a message
is generated to the primary FCS to try to correct and resynchronize with the rest of the switches in the
fabric.
Recommended
Action
Use the secFabricShow command to check whether any of the switches in the fabric encountered an
error. If one or more of the switches is not in the ready state, and you have reason to believe that the
error is the result of a possible security breach, take appropriate action as defined by your enterprise
security policy.
SEC-1006
Message
Security statistics error: Failed to reset due to invalid .
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that invalid data has been received for any statistic-related command for security
(secStatsShow or secStatsReset). The counter is updated automatically when a security violation
occurs. This message may also occur if the updating counter fails.
Recommended
Action
If the message is the result of a user command, retry the statistic command.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.