Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 195)

Fabric OS Message Reference 173
53-1003140-01
AUTH-3007
5
Recommended
Action
Check the connection port for a possible security attack.
Check the shared secrets using the secAuthSecret command and reinitialize authentication using the
portDisable and portEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
AUTH-3007
Message
Event: , Status: failed, Info: Port disabled due to
receiving an authentication reject with code '' and Explanation
''.
Message Type
AUDIT
Class
SECURITY
Severity
INFO
Probable Cause
Indicates that the specified port was disabled because it received an authentication-reject response from
the connected switch or device.
The error may indicate that an invalid entity tried to connect to the switch.
Recommended
Action
Check the connection port for a possible security attack.
Check the shared secrets using the secAuthSecret command and reinitialize authentication using the
portDisable and portEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
AUTH-3008
Message
Event: , Status: failed, Info: Port has been disabled
due to authentication failure with code '' and explanation
''.
Message Type
AUDIT
Class
SECURITY
Severity
INFO
Probable Cause
Indicates that the specified port has been disabled because the connecting switch or device failed to
authenticate.
The error may indicate that an invalid entity tried to connect to the switch.
Recommended
Action
Check the connection port for a possible security attack.
Check the shared secrets using the secAuthSecret command and reinitialize authentication using the
portDisable and portEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.