Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 223)

Fabric OS Message Reference 201
53-1003140-01
BM-1007
5
Recommended
Action
Configure the blade so that it will persistently enable the ports.
BM-1007
Message
If set, clear EX/VEX/FC Fastwrite configuration for all ports for blade in slot
.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates the specified blade was detected for the first time after an FR4-18i was previously configured in
the same slot. The new blade requires the specified port configurations to be cleared.
Recommended
Action
No action is required. The blade ports are cleared automatically.
BM-1008
Message
Download of blade firmware failed for blade in slot . Reissue
firmwaredownload to recover.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the automatic firmware upgrade on the blade failed because the blade firmware version
was detected to be different from the control processor (CP) firmware version.
Recommended
Action
Execute the firmwareDownload command to recover the blade.
BM-1009
Message
Firmwaredownload timed-out for application processor. Faulting switch.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the firmware download on the application processor (AP) blade failed.
Recommended
Action
Execute the slotPowerOff and slotPowerOn commands or reseat the affected blade.