Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 925)

Fabric OS Message Reference 903
53-1003140-01
SULB-1035
5
SULB-1035
Message
An error has occurred during relocation of the internal image.
Message Type
AUDIT | LOG
Class
FIRMWARE
Severity
ERROR
Probable Cause
Indicates that an error has occurred during the relocation of the internal image. The error may be caused
by inconsistent internal firmware image. It may also be caused by an internal Ethernet issue or a
persistent storage hardware failure.
Recommended
Action
Reset the switch. This will cause the internal image to be relocated again. If the problem persists, contact
your switch service provider.
SULB-1036
Message
.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates the version running in the system. This is generally logged before download and after download
of the firmware to store version information.
Recommended
Action
No action is required.
SULB-1037
Message
HCL failed. Reboot the switch manually using the reboot command. However, it will
disrupt the FC traffic.
Message Type
AUDIT | LOG | FFDC
Class
FIRMWARE
Severity
ERROR
Probable Cause
Indicates that Hot Code Load (HCL) has failed. Many reasons, such as a domain not confirmed, can
cause this failure.
Recommended
Action
Run the reboot command to reboot the switch manually.