Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 192)

170 Fabric OS Message Reference
53-1003140-01
AUTH-1048
5
AUTH-1048
Message
Stopping synchronization of the system due to incompatibility
with standby CP.
Message Type
AUDIT | LOG
Class
SECURITY
Severity
ERROR
Probable Cause
Indicates that the software version on the standby control processor (CP) is incompatible with this
software feature enabled in this Fabric OS firmware version because the in-flight encryption feature
supports both DH-CHAP and FCAP protocols.
Recommended
Action
Upgrade the software on the standby CP or disable the software feature on this CP.
To allow standby synchronization, use the DH-CHAP protocol only for in-flight encryption and disable
FCAP protocol in authutil. Use the authutil --set -a "protocol type" command to configure the
DH-CHAP protocol.
AUTH-1049
Message
Slave port has been disabled, as Master port
number> was disabled because of authentication failure/rejection.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the specified slave port has been disabled because it received an authentication-reject
response from the connected switch or device. The error informs that the slave port is disabled due to
master port authentication failure or rejection.
Recommended
Action
Check the connection port for a possible security attack.
Check the shared secrets using the secAuthSecret command or check certificates using the
secCertUtil command, and reinitialize authentication using the authutil --authinit command.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.