Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 809)

Fabric OS Message Reference 787
53-1003140-01
SEC-1157
5
SEC-1157
Message
PID Change failed: .
Message Type
LOG
Severity
INFO
Probable Cause
Indicates the provisioning resources for a security policy failed because of low memory or internal error.
The status values can be defined, active, or both. A negative value means that a policy set was failed by
the daemon.
Recommended
Action
Retry the failed command.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
SEC-1158
Message
Invalid name .
Message Type
LOG
Severity
INFO
Probable Cause
Indicates the specified name is invalid. The name can be a policy name or a switch name.
Recommended
Action
Enter a valid name.
SEC-1159
Message
Non_Reachable domain .
Message Type
LOG
Severity
INFO
Probable Cause
Indicates a corruption occurred during the distribution of the security database. This can only occur when
the primary fabric configuration server (FCS) distributes the security database to the other switches in
the fabric, and then local validation finds the error in the security database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database may not be correctly updated for that
specific switch.