Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 898)

876 Fabric OS Message Reference
53-1003140-01
SSMD-1007
5
SSMD-1007
Message
Error while removing ACL from interface .
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that an error occurred while programming a TCAM entry on the specified interface.
Recommended
Action
Try again after some time. If the problem persists, execute the supportSave command and then restart
or power cycle the switch.
SSMD-1008
Message
Apptype TCAM Table full for Slot: chip:.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the application type TCAM table is full on the specified chip.
Recommended
Action
Remove the unused protocol-based VLAN classifiers and Layer 2 extended access control lists (ACLs).
SSMD-1200
Message
QoS failed programming ASIC / Multicast Rate
Limit.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that DCE SSM encountered an unexpected error in programming the dataplane
application-specific integrated circuit (ASIC) for enforcing the Multicast Rate Limit feature.
Recommended
Action
Delete and reapply the Quality of Service (QoS) Multicast Rate Limit policy using the qos rcv-queue
multicast rate-limit command.
If the problem persists, restart or power cycle the switch.