Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 696)

674 Fabric OS Message Reference
53-1003140-01
MS-1003
5
MS-1003
Message
MS detected Unstable Fabric().
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the Management Server (MS) detected an unstable fabric; the command or operation may
not be successfully completed. This message is often transitory.
The message string value can be one of the following:
• DOMAIN_INVALID for a req from: The domain is invalid for a request.
• No WWN for: Unable to acquire the World Wide Name (WWN) for the corresponding domain.
The domain number is the target domain that caused error.
Recommended
Action
The fabric may be reconfiguring, forming, or merging. Wait a few minutes and try the operation again.
Execute the fabricShow command or the secFabricShow command to verify that the number of
domains matches the Management Server known domains.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
MS-1004
Message
MS detected ONLY 1 Domain(d=).
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the Management Server (MS) detected an unstable count of domains in its own local
resource. This message is often transitory.
Recommended
Action
The fabric may be reconfiguring, forming, or merging. Wait a few minutes and try the operation again.
Execute the fabricShow command or the secFabricShow command to verify that the number of
domains matches the Management Server known domains.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.