Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 186)

164 Fabric OS Message Reference
53-1003140-01
AUTH-1032
5
Recommended
Action
Reset the secret value using the secAuthSecret command.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
AUTH-1032
Message
Failed to generate for payload: length
length>, error code , port .
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the authentication process failed to generate specific data (challenge, nonce, or response
data) for an authentication payload. This usually relates to internal failure.
A nonce is a single-use, usually random value used in authentication protocols to prevent replay attacks.
Usually this problem is transient. The authentication may fail.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
AUTH-1033
Message
Disable port due to unauthorized switch .
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that an entity was not configured in the Switch Connection Control (SCC) policy and tried to
connect to the port.
Recommended
Action
Add World Wide Name (WWN) of the entity to the SCC policy and reinitialize authentication by using the
portDisable and portEnable commands or the switchDisable and switchEnable commands.
AUTH-1034
Message
Failed to validate name in : port
number>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the specified entity name in the payload is not in the correct format.