Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 591)

Fabric OS Message Reference 569
53-1003140-01
FW-1501
5
FW-1501
Message
Mail overflow cleared - alerts discarded.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the mail overflow condition has cleared.
Recommended
Action
No action is required.
FW-1502
Message
Invalid Email address is configured from pre-7.0.0 config file.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the configuration file has invalid e-mail addresses.
Recommended
Action
Reconfigure a valid e-mail address.
FW-1510
Message
threshold exceeded(High=). Current value is
: Port disabled.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the specified port is now disabled because the link on this port had multiple link failures
that exceeded the Fabric Watch threshold on the port. Both physical and hardware problems can cause
link failures. Link failures frequently occur due to a loss of synchronization. Link failures also occur due to
hardware failures, a defective small form-factor pluggable (SFP), or a faulty cable.
Protocol errors indicates CRC sum disparity. Occasionally, these errors occur due to software glitches.
Persistent errors occur due to hardware problems.
Recommended
Action
Check for concurrent loss of synchronization errors. Check the SFP and the cable. Then, enable the port
using the portEnable command.