Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 757)

Fabric OS Message Reference 735
53-1003140-01
RCS-1004
5
RCS-1004
Message
Application() not registered.().
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the specified application did not register with reliable commit service (RCS).
Recommended
Action
Run the haShow command to view the HA state.
Run the haDisable and haEnable commands.
Run the rcsInfoShow command to view RCS capability on the fabric. RCS is supported in Fabric OS
v2.6, v3.1 and later, and v4.1 and later.
Run the firmwareDownload command to upgrade the firmware for any switches that do not support
RCS.
RCS-1005
Message
Phase , Application returned ,
0x.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that a receiving switch is rejecting the specified reliable commit service (RCS) phase.
Recommended
Action
If the reject is in the acquire change authorization (ACA) phase, wait for several minutes and then retry
the operation from the sender switch.
If the reject is in the stage fabric configuration (SFC) phase, check if the application license exists for the
local domain and if the application data is compatible.
RCS-1006
Message
State , Application AD, RCS
CM. Domain returned 0x. App Response
Code .
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the specified domain rejected a reliable commit service (RCS) phase initiated by an
application on the local switch.
• If the reject phase is acquire change authorization (ACA), the remote domain may be busy and
could not process the new request.
• If the reject phase is stage fabric configuration (SFC), the data sent by the application may not
be compatible or the domain does not have the license to support that application.